Audi a6l 2.4 all key lost, use Xhorse VVDI Pro and VVDI2 make key
Audi A6l 2.4 all key lost and I use VVDI2 key programmer by Xhorse Company to make key and remote key successfully, the following paragraphs are the detailed procedure, hope it helps.
Remove engine from Audi a6l 2.4
Open Engine cover, find out the Engine position, disassemble engine.
Remove the engine ECU
Take apart engine ECU.
Next is to read this 95320 chip.
Remove 95320 chip and put it on the VVDI pro to read data.
Open VVDI pro
Select type, manufacture and model
Click “New”
Click “Read”
Successfully Read out data, click “Save”.
Take out chip from VVDI Pro and desoder the chip back to the engine ECU.
Reinstall engine ECU back to the Audi.
Open VVDI2 and click “Audi” option.
Select “Special function”
Select “EEPROM data processing tool”
Firstly calculate CS code
Select “ECU Simons PPDIX – Reset component protection data”
Click “Load” the load the data that read out just now, then click open.
This is CS code, take a picture to record it.
Next is to calculate it’s PIN code
Select “ECU Simons PPDIX – Security Access Code”
Click “Load” again to load the file.
PIN code is read out, record PIN code with photograph.
The first step is prepared well.
Open VVDI2, click “Learning Key”- “Audi A6/Q7” Option.
Input the CS and PIN code that read out by VVDI pro, then you will see the button “Learning Key” and “Generate dealer key” are enabled.
Put OEM chip and 8E chip into VVDI2 key programmer.
Click “Generate dealer key”
Generate dealer key is done.
Next is to learning key
Disconnect the short insurance line.
Connect back
Take out the chip from VVDI2 and put it into ignition data coil.
Click “Learning Key”
Open and close car door, turn on ignition, press down brake.
Click “Learning Key”.
learning successfully.
Next is to read out EZS-KESSY(J518)EEPROM.
Click “ok”, select Chip type 9S1201128, the aim to read EZS-KESSY(J518)EEPROM is to generate OEM remote control.
Save EZS-KESSY(J518)EEPROM.
Generate OEM remote control.
Vertical put remote controller on the coil of VVDI2.
Click “Open”
Following the prompt the put the remote controller, click “Next”
Controller is generated successfully, assembled key and to test.
Test the key whether it can start the A6L.
The car can start.
Prepare to test Remote control.
Remote control is working.
Done.
More VVDI Product Information VVDI Prog Please Search: www.wobd2.com
VVDIVVDI PRO
Aucun commentaire:
Enregistrer un commentaire